MEMORY
TROUBLESHOOTING
HELMET/HEAD MOUNTING
(Continued)
HELMET/HEAD MOUNTING
1
2
ROTATE the front
section of the
MOUNTING CASE
COUNTERCLOCK-
WISE (approx.
1
/
4
”)
and REMOVE.
INSERT the
ACTION SHOT
™
CAMERA into the rear
section of the MOUNTING
CASE and REPLACE the front section
of the MOUNTING CASE.
BOARD MOUNTING
4
4.1
4.2
Follow STEPS 1 – 3 in the
HELMET MOUNTING section.
REMOVE the PROTECTIVE
COVERING (4.1) and PRESS the
MOUNT onto a CLEAN SMOOTH
SURFACE (4.2).
OR, use #2 or #3 SCREWS (not included) to secure the
ADHESIVE MOUNT to a surface.
INSERT the MOUNTING CASE onto the ADHESIVE
MOUNT.
ROTATE the MOUNTING CASE CLOCKWISE for PORTRAIT
FORMAT, or COUNTERCLOCKWISE for LANDSCAPE
FORMAT.
5
6
3
4
ROTATE the front section
of the MOUNTING CASE
CLOCKWISE
(approx.
1
/
4
”).
INSERT the
MOUNTING CASE
onto the
HELMET/HEAD
MOUNTING
STRAP.
5
For
LANDSCAPE
FORMAT
ROTATE the
MOUNTING CASE
COUNTERCLOCKWISE.
OR, for
PORTRAIT FORMAT
ROTATE the MOUNTING CASE
CLOCKWISE.
6
INSTALL the
HELMET/HEAD
MOUNTING STRAP
onto your SAFETY
HELMET or your HEAD.
7
TIGHTEN the
HELMET/HEAD
MOUNTING
STRAP and PRESS the
STRAP against the
LOOPED FASTENER to
secure.
1
2
SLIDE the MICRO
SD CARD SLOT
COVER UP.
INSERT the MICRO SD
MEMORY CARD into the
MICRO SD CARD SLOT.
3
4
Press and Hold the REC / STOP
BUTTON and the POWER / MODE
BUTTON for 5 SECONDS to format the
MICRO SD MEMORY CARD.
CLOSE the MICRO SD CARD SLOT.
To remove the MICRO SD MEMORY CARD,
PRESS IN and RELEASE.
Then, PULL the memory card out.
The INTERNAL MEMORY of the Action Shot
™
Camera is 128mb. It will store approximately 2.5 minutes of video or 2,000 still
images. When the INTERNAL MEMORY is full, the LED INDICATOR blinks rapidly for 3 seconds and the camera makes a sound.
Stop recording and transfer your video or images to your computer (see above).
Upgrade the Action Shot
™
Camera’s memory by purchasing a MICRO SD MEMORY CARD (not included). A 4GB Micro SD
Memory Card will store approximately 81 minutes of video or 60,000 still images. When the MICRO SD MEMORY CARD is in
the camera, it disables the camera’s internal memory, and all new images are recorded onto it.
The Camera will not turn ON
– Make sure the Camera is fully
charged (See CHARGING THE BATTERY section).
The Camera will still not turn ON
– Insert a PAPER CLIP into
the RESET HOLE and PRESS the RESET BUTTON.
The Camera will not turn OFF
– Insert a PAPER CLIP into the
RESET HOLE and PRESS the RESET BUTTON.
The Camera is turned ON, but...
•
The Camera will not Record
– Insert a PAPER CLIP into the RESET HOLE and PRESS the RESET BUTTON.
•
The Camera will not Take Photos
– Insert a PAPER CLIP into the RESET HOLE and PRESS the RESET BUTTON.
Micro SD Card
Slot Cover
Micro SD Card Slot Cover
