JAGER PRO M.I.N.E., Руководство по эксплуатации

Страница: 19 / 32

19
PAIRING M.I.N.E.™ CAMERA TRANSMITTER TO
CONTROL BOX RECEIVER
The most efficient way to pair M.I.N.E.™ Camera with control box receiver is to conduct these
steps before mounting the camera
THIS STEP IS ONLY A FUNCTION OF THE M.I.N.E.™ CAMERA.
THE I.C.E.™ CAMERA DOES NOT U TILISE AN INTERNAL TRANSMITTER.
The M.I.N.E.™ Camera has an internal transmitter on the circuit board and must be located within 45
meters of the M.I.N.E.™ Gate to operate correctly. Users must manually pair camera transmitter signal to
each control box receiver the first time they are linked together. It is not necessary to pair camera
transmitter to receiver more than one time unless it has been paired to another device.
Pairing Steps:
1.
Press and release “frequency select” button (C) and red
light (B) will flash either three times or five times. Press
and release “frequency select” button (C) until red light
(B) only flashes three times.
2.
Move camera selector switch from OFF to Setup.
3.
Press and release “pair to transmitter” button (A) and red
light (B) will illuminate for 15 seconds. Users have only
15 seconds to complete step 4 once step 3 has been
initiated.
4.
Press a nd release camera “left arrow” (E) then press and release camera “right arrow” (F) to
send a manual RF signal to control box receiver. RF Trigger will appear at bottom of camera
screen. Red receiver light (B) should flash five times then no longer illuminate.
5.
Ensure M.I.N.E.™ Camera and receiver are pa ired. Press and release camera “left arrow” (E)
then press and release camera “right arrow” ( F) button while observing green light (D) illuminates.
Test successful.
NOTE: This procedure will activate actuator and release gate.
CRUSH HAZARD: Stand clear of gate as it
could cause bodily harm! Ensure safety clip
is installed if gate is in the UP position.