Jäger Z62-M260.23 S5, Руководство пользователя

Страница: 20 / 36

Installation
Item no. 10202024, Revision 02 20 ( 36 )
8 Installation
Before installation:
Ü Check the HF spindle for damage and ensure that it is complete.
If the HF spindle has been stored for a long period:
Ü
Carry out all steps in the Commissioning after storage [
}
23] section.
8.1 Installing the HF spindle
Connect media and cables with a
flexible connection.
Complete the following steps in sequence to install the HF spindle:
Ü
Remove the sealing plugs that protect the connections against damage
and contamination during transportation.
Ü Instead of these sealing plugs, install the appropriate hose fittings.
Ü Install the corresponding hoses in the hose fittings
Ü
Make sure that the connections are flexible and free of strain.
Ü Seal all connections for compressed air axially in relation to the tightening
direction.
Ü If the HF spindle is equipped with sealing air:
Ä Make sure that no air flow can occur in the bearing area.
Ä Always use sealed cable boxes when connecting electrical lines.
Ü
Mount the HF spindle on the machine.
Ü Connect the hoses to the connection of the respective media.
Ü Connect the connector of the operating connection lines to the relevant
connection of the HF spindle and to the frequency converter.
Ü Lock the connectors.
Note: Connect the SpeedTEC quick locking connector.
u
For the combination SpeedTEC connector plug/SpeedTEC cable plug:
u Remove the O ring on the SpeedTEC connector plug.
8.2 Diameter of media supply line
Ü The nominal size of the media supply lines can be found in the following
table:
DN Medium D1 D2
2.8 Compressed air 2.8 mm
7
/
64
" 4 mm
5
/
32
"
4
Compressed air 4 mm
5
/
32
" 6 mm
15
/
64
"
6 Compressed air 6 mm
15
/
64
" 8 mm
5
/
16
"