107
EN
6. SETTINGS VIA CIRCUIT BOARD CONTROLLER
6.1. ADJUSTING THE WATER TEMPERATURE
The unit starts from the set temperature
/
.
6.1.1. Setting the maximum water temperature for cooling
By setting the temperature lower, the unit will start later. If the water temperature is set higher, the unit
will start faster .
1. Start setup mode: hold the [
-
] button until the
blue LED
flashes 5x and release .
2.
3. Exit setup mode: hold the [
-
] button until the
blue LED
flashes 5x and release .
6.1.2. set minimum water temperature heating
By setting the temperature higher, the unit will start later. If the water temperature is set lower, the
unit will start faster .
When using a heat pump, it may be necessary to set the water temperature at a lower setting .
1. Exit setup mode: hold the [
+
] button until the
red LED
flashes 5x and release .
2.
12 ̊C
14 ̊C
16 ̊C
18 ̊C
20 ̊C
22 ̊C
24 ̊C
26 ̊C
The blue LED flashes quickly
as soon as the
minimum temperature is reached.
.
The blue LED flashes quickly
as soon as the
minimum temperature is reached.
.
The red LED flashes quickly
as soon
as
the
maximum temperature is reached.
.
The red LED flashes quickly
as soon
as
the
maximum temperature is reached.
.
Automatic control:
The green LED
lights up when the water temperature (supply water) is lower than the
set temperature
Automatic control:
The green LED
lights when the water temperature (supply water) exceeds the set
temperature .
Briefly press the [-] or [+] button to adjust the set tempe-
rature .
Briefly press the [-] or [+] button to adjust the set tempe-
rature .
24 ̊C
26 ̊C
28 ̊C
30 ̊C
32 ̊C
34 ̊C
36 ̊C
38 ̊C
3. Exit setup mode: hold the [
+
] button until the
red LED
flashes 5x and release .
After 30 seconds, the new settings are automatically saved and the device returns to the
selected mode. .
1
-
1
-
1
-
1
-
24
28