44
9.
To completely flush the old water from the plumbing lines: allow fresh water to fill into
the foot-
well area while the old water con nues to be pumped out. Always keep at least
10cm (4 in.) of water in the foot-well so that pump 1 remains primed.
10.
When the water from the drain hose turns clear (indica ng fresh fill water), flush is com-
plete.
11.
Turn OFF the filtra on pump.
12. Close the drain-hose bib on the swim spa plumbing line and con-
nue filling swim spa with fresh water.
13. Place cover on swim spa (to avoid splash-out).
14.
Open filtra on pump return gate valve.
15.
Press any bu on on the topside control panel (other than the pump 1 bu on) to take
the system out of STANDBY/DRAIN ASSIST
mode. Filtra on pump and the heater will ac-
vate to circulate and heat the water while filling con nues. This also reduces the possi-
bility of an airlock occurring.
16.
Con nue adding fresh fill water un l level is approximately 19mm (3/4 in.) from the top
of the skimmer opening.
12.3 Cleaning the Swim Spa Interior
To preserve the sheen of your swim spa’s surface, it is crucial that you avoid using abrasive
cleaners or cleaners which have adverse chemical effect on the surface. If you are not certain
as to the suitability of a par cular cleanser, consult your authorized Jacuzzi dealer. We recom-
mend using Jacuzzi’s Spa All Purpose Cleaner to clean the swim spa’s interior surface. Use ex-
treme care to assure that no soap residue is le on the surface. This could cause severe
sudsing when the swim spa is refilled. Jacuzzi chemicals are for use in the U.S. only.
12.4 Pillow Care
Clean the headrests in your swim spa as needed by wiping them with a cloth with soapy wa-
ter. It is not necessary to remove the headrests for cleaning. To remove headrests for long
term storage or replacement, grasp both ends of each headrest and gently pull inward to-
wards the center of the swim spa. To reinstall, over moun ng strip and press down un l head-
rest moun ng bracket emits a “click” sound. Then adjust the headrest height by simply mov-
ing up or down as desired.
