Jacuzzi Steam & Shower Base SEDONA, Инструкция по установке и эксплуатации

Страница: 4 / 20

*SteamPro supplied with NEMA 6-50P plug. NEMA 6-50R receptacle required.
Product specifications are subject to change without notice.
SPECIFICATIONS
DIMENSIONS
60" (1524 mm) L
32" ( 813 mm) W
18-5/8" ( 473 mm) H
TOTAL WEIGHT/
FLOOR LOADING
310 lbs
(141 kg)
/23 lb/sq. ft.
(112 kg/sq. m)
PRODUCT
WEIGHT
110 lb
(50 kg)
ELECTRICAL
*230 VAC, 60 Hz.
40 AMP, 3 Wire
Requires a
Dedicated Separate
Circuit.
Important: Read complete instructions before beginning installation.
Each shower base is shipped with a drain and stainless steel strainer
Remove the shower base from the carton. Do not destroy the shipping carton until after satisfactory
inspection of the product.
Immediately upon receipt, inspect the base before installing. Should inspection reveal any damage or defect in the
finish, do not install the base. Damage or defect to the finish claimed after the base is installed is excluded from the
warranty. Jacuzzi Whirlpool Bath’s responsibility for shipping damage ceases upon delivery of the products in good
order to the carrier. Refer any claims for damage to the carrier. For definitions of warranty coverage and limitations,
refer to the published warranty information packaged with the product. Jacuzzi Whirlpool Bath is not responsible for
any defect that could have been discovered, repaired, or avoided by following this inspection and testing procedure.
Plan the installation in relation to the finished wall surfaces. Take into account the dimensions of both the shower
base and the shower door enclosure to be used with it.
NOTE: Damage or defects which could have been discovered and repaired prior to installation and which are claimed
after final installation of the product are excluded from our warranty.
60"
16-5/8"
18-5/8"
TOP VIEW
SIDE VIEW
8-1/2"
32"
1" TILE FLANGE
(LEFT HAND UNIT SHOWN)
SERVICE
ACCESS
RECEPTACLE
LOCATION
(RECEPTACLE TO BE
ACCESSIBLE FROM
SERVICE ACCESS)
STEAM HEAD AND SHIELD
( PRE-INSTALLED AND
CONNECTED TO
STEAM GENERATOR)
LOCATION FOR
INCOMING WATER
SUPPLY LINE TO
STEAMER (INSTALLED
AND PREPLUMBED
WITH 3/8" COPPER
TUBINGTO STEAM
GENERATOR WITH
SHUT OFF VALVE)
SHUT OFF
VALVE
STEAM
GENERATOR
45-3/8"
2