Jacuzzi J-400 Series, Руководство пользователя

Страница: 7 / 104

Page 1
J-400 Series
1.0 Important spa Owner Information
Your Jacuzzi® spa is constructed to the highest standards and is capable
of providing many years of trouble-free use. However, because heat
retentive materials are utilized to insulate the spa for efficient operation,
an uncovered spa surface directly exposed to sunlight and high tempera-
tures for an extended period is subject to permanent damage. Damage
caused by exposing the spa to this abuse is not covered under warranty.
We recommend that you always keep the spa full of water when it is
exposed to direct sunlight and that you keep the Jacuzzi insulating cover
in place at all times when the spa is not in use. Read and carefully follow
the requirements for your spa’s support base found in the Section 4.0
titled, “Choosing a Location” (page 8 ).
Jacuzzi® spas constantly strives to offer the finest spas available,
therefore, modifications and enhancements may be made which affect
the specifications, illustrations and/or instructions contained herein.
2.0 FCC notice
This device complies with part 15 of the FCC Rules. Operation is subject
to the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for
a Class B Digital Device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses
and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will
not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
1. Rearrange or relocate the receiving antenna;
2. Increase the separation between the equipment and receiver;
3. Connect the equipment into an outlet on a circuit different from the
circuit connected;
4. Consult the dealer or an experienced radio/TV technician for help.
(Changes or modifications not expressly approved by the party
responsible for FCC compliance could void the user’s authority to
operate this equipment.)
2.1 Industry Canada (IC) Information
The installer of this radio equipment must ensure that the antenna is
located or pointed such that it does not emit RF field in excess of Health
Canada limits for the general population; consult Safety Code 6,
obtainable from Health Canada’s website: www.hc-sc.gc.ca/rpb.