Jacuzzi J-400 Series, Руководство пользователя

Страница: 24 / 104

Page 18
J-400 Series
5. add start-up Chemicals
Add the spa water chemicals as recommended by your authorized
Jacuzzi spa dealer. See Section titled “Water Quality Maintenan
ce”
(page 71 ) for general guidance.
warnInG:
rIsK OF POIsOnInG Or DeaTH.
Never leave chemicals opened and accessible to anyone. Use
chemicals according to the vendors instructions. Always store
chemicals in a safe and/or locked location. Keep away from
and out of reach of children.
!
6. establish a stable sanitizer reading
Establish a stable sanitizer reading between 3.0-4.0 ppm chlorine
or 2.0-4.0 ppm bromine. To ensure healthy water conditions, always
maintain a constant sanitizer reading within the levels recommended
by the Association of Pool and Spa Professionals/USA printed on the
inside cover of this manual. If sanitizer levels cannot be stabilized,
perform the Decontamination Procedures on the following page.
note: The “Decontamination Procedure” should also be used after
the spa has been “Winterized” (sec. 14.7, page 7 0) or has been sitting
without power for an extended period.
7. set spa To Heat
To warm spa water to a comfortable
temperature, follow these steps:
The LCD display on the control panel •
displays the actual temperature of the spa
water. Press either the uP or DOwn button
on the Navigational Quad Keypad to increase or decrease the water
temperature by 1 degree.
The heater will
• turn off 1 degree above set temperature and turn on 1
degree below set temperature.
Important Heater Details:
The maximum temperature for which the spa can be set is 104 °F •
(40 °C) and the minimum is 80 °F (27 °C).
For North American spas: With a 50 amp service, turn off one •
of the jet pumps to operate heater. With a 30 amp service, turn
off both jet pumps to operate heater. With a 60 amp service, the
heater will operate with both jet pumps on.
Setting the thermostat at maximum will not accelerate the heating •
process. This will only result in a higher ultimate temperature.
The heater operates until the water reaches • 1 degree above the
programmed “set temperature”, then turns off. The heater will
reactivate after the water cools to approximately 1 degree below
the “set temperature.”
UP
DOWN
RIGHT
LEFT
SPLASH