page 24
10.7 Filtration Modes for Spas with Circulation Pump Option
If your spa
is not equipped
with the circulation pump option, disregard
this section and refer to page 23 for filter cycle programming details.
Standard Filtration/Heating Modes (F0-F3)
(Heater automatically turns on during any heat call while in any
Standard mode).
F0 5 minutes of filtration per day (one 5 minute “Blow-Out”
cycle every 24 hours to purge all plumbing lines)
F1 1 hour of filtration per day (one 30-minute cycle every
twelve hours);
this is the factory default setting.
F2 1.5 hours of filtration per day (one 30-minute cycle
every eight hours).
F3 2 hours of filtration per day (one 30-minute cycle every
six hours).
Economy Filtration/Heating Modes (F4-F6)
(Heater can only turn on during an active filter cycle while
in any economy mode).
F4 1 hour of filtration/heating per day (one 30-minute cycle
every twelve hours).
F5 1.5 hours of filtration/heating per day (one 30-minute
cycle every eight hours).
F6 2 hours of filtration/heating per day (one 30-minute
cycle every six hours).
Lock Modes (L1-L2)
L1 Lock Out (disables all spa functions to permit filter
cleaning).
L2 Lock Mode (disables the jets and light buttons to pre
-
vent unauthorized use of spa). Filtration/heating cycle
will continue to operate as programmed in this mode.
The temperature display flashes when this function
is enable. Example: the “F3” filtration/heating cycle was enabled
prior to choosing lock mode. The spa continues to perform the
“F3” cycle until lock mode is canceled, allowing another cycle to be
selected.
Filter Cycle Setup Example
To set a time for the first filtration/heating cycle, simply turn power on to
the spa two minutes prior to the desired time. EXAMPLE: If you desire
your first filtration/heating cycle to begin at 10:00 AM turn off power to
the spa and turn it back on again at 9:58 AM.
Note: start time is approxi-
mate and may vary slightly from day to day.
