Jacuzzi J - 210, Руководство пользователя

Страница: 19 / 44

page 5
4. Activate Jets Pump 1
Depress the JETS button on the control panel once to activate
jets pump #.
5. Add Start-Up Chemicals
Add the spa water chemicals as recommended by your authorized
Jacuzzi dealer. See section 3.0 “Water Quality Maintenance”
(page 29) for general guidance.
6. Establish A Stable Sanitizer Reading
Establish a stable sanitizer reading between 3.0-4.0 ppm Chlorine or
2.0-4.0 ppm Bromine. To ensure healthy water conditions, always
maintain a constant sanitizer reading within the levels recommended
by the Association of Pool And Spa Professionals/USA printed on
the inside cover of this manual. If sanitizer levels cannot be stabi-
lized, perform the decontamination procedure steps 9-5 on page
6-7. Note: the “decontamination procedure” steps 9-15 should
also be used after the spa has been “Winterized” (section 12.7,
page 28) or has been sitting without power for an extended period.
7. Set Spa To Heat
To warm spa water to a comfortable temperature, follow these
steps:
• The LCD display on the control panel displays the actual tempera-
ture of the spa water. Press either the COOLER (-) or WARMER
(+) button once to display the “set” temperature for 5 seconds. If
you want the water to heat to a different temperature, simply press
COOLER (-) or WARMER (+) within 5 seconds. The set tempera-
ture increases or decreases by one degree each time one of these
buttons is pressed.
• The heater will turn off when the temperature corresponding to the
thermostat setting is achieved.
Important Heater Details:
• The maximum water temperature setting for your spa is 04°F
(40°C) and the minimum setting is 65°F (8°C).
• Setting the thermostat at maximum will not accelerate the heating
process. This will only result in a higher ultimate temperature.
• The heater operates until the water reaches the programmed “set
temperature”, then turns off. The heater will reactivate after the
water cools to approximately .5° below the set temperature.
8 . Place Cover On Spa
• Keeping the insulating cover in place anytime the spa is not in use