Jacuzzi J-200 Series, Руководство пользователя

Страница: 50 / 64

J-200
UV BULB REPLACEMENT AND QUARTZ TUBE MAINTENANCE:
Note: Location of
CLEARRAY
System and connection may vary by
model.
1. Turn the breaker to the spa OFF. DRAIN YOUR SPA.
Note: If you are only replacing the UV bulb then the spa
does not have to be drained. You will need to drain it if
you are replacing or cleaning the quartz tube.
2. Once the UV bulb has cooled off remove the
CLEARRAY
System enclosure cover (9) and gasket
(8) by removing the four screws (10). This will expose the
UV bulb and connections, Figure 2.
3. Disconnect UV bulb socket (7) from the power cord socket (11),
Figure 3.
4. Slowly remove the UV bulb (3) out of the quartz tube, Figure 4.
5. Remove the quartz seal compression nut (5) by
turning it counterclockwise, Figure 5. Use a pair
of channel-lock pliers if needed, Figure 6. You will
notice that there is a stainless steel compression
washer (4) which slides over the quartz tube, save
the washer (4) for later use, Figure 7.
6. Now you are ready to clean or replace the quartz tube
(2). For cleaning the quartz tube (2), follow steps 7 and 8 then proceed
from step 9. For replacing quartz tube (2), skip steps 7 and 8 and
proceed from step 9.
7. Cleaning quartz tube: Clean the quartz tube by wiping, until clear,
using a paper towel or a dry cotton cloth. If needed, a household tub
and shower lime removal product can be used.
WARNING :
Do not use abrasive cleaners as they can
scratch the quartz tube surface.
!
8. Rinse the quartz tube with clean water to completely remove any
cleaning products that were used in step 7.
9. Replacing quartz tube: You will notice that the new quartz tube
does not have a black cushion on the domed end as the old quartz
tube does. This is normal as the cushion was provided with the
DANGER:
NEVER REMOVE COVER WITHOUT FIRST
TURNING OFF AT POWER SOURCE AND DRAINING THE
SPA.
!
FIGURE 2
FIGURE 3
FIGURE 6
7
11
FIGURE 5 FIGURE 4
5
2
4
3
FIGURE 7
8
46