Jacuzzi frame in2, Использование и обслуживание

Страница: 59 / 108

59
X
After the filling phase, the water is heated .
20
The steam starts to exit almost immediately from the nozzles
(dispensers) located at the base of the seat and then the count-
down of the duration of the Turkish bath begins.
When steam is first produced, hot condensate water may
exit the nozzles; this will stop once the temperature has
been stabilised.
X
The temperature value is shown by the configuration of the
“thermometer” symbol:
- during the heating phase, the luminous sectors will turn on and
off in succession.
- when a temperature of approx. 30° is reached in the shower unit,
all sectors remain lit up; in any case, the Turkish bath session may be
started even while the thermostat is flashing.
Q TT model
Press the "Turkish bath" key.
X
This function lasts 45 minutes (value cannot be changed).
The steam will start to exit almost immediately from the nozzles
at the base of the seat, and the countdown of the duration of the
Turkish bath begins.
When steam is first produced, hot condensate water may
exit the nozzles; this will stop once the temperature has
been stabilised.
Q
All models
When this time has passed, the function stops automatically, an
acoustic signal sounds and the "waterfall" key will start to flash:
X
If this key is pressed within a few seconds, a jet (or water-
fall) of cold water can be activated for a few seconds, which will
exit from an opening located on the top of the panel where the
brassware is located.
If you do not intend to use this function, wait a few seconds
until the key stops flashing.
X
When the waterfall has stopped, or when the respective pe-
riod of time has passed, the steam generator washing cycle will
start (during this phase, the "Turkish bath" key will flash and no
other hydraulic function can be activated).
X
When the washing cycle is complete, the key will stop flash-
ing and the control panel will return to the “awaiting instruc-
tions” mode
.
X
The function may be interrupted at any moment by press-
ing the "Turkish bath" key (the steam generator will then be
washed, after which the control panel returns to the “awaiting
instructions” mode).
ATTENTION! The emerging steam has a tempera-
ture close to 100 °C! Do not rest legs on the steam
outlet, keeping them at least 40 cm from the outlet
nozzles.
- Make sure that the door of the shower unit is closed, other-
wise the temperature inside may not reach an optimal value:
this could generate an error (alarm code AL7, see the “Error
conditions” chapter) and cause the system to interrupt the
function.