![background image](http://html1.mh-extra.com/html/jacuzzi/era-series/era-series_installation-and-operation-instructions-manual_3299788016.webp)
Era™ Freestanding Bath
Era™ Freestanding Bath
Page 16
www.jacuzzi.com
Installation and Operation
English
Era™ Freestanding Bath
Step 6
X
X
Place the base in position (line up the edge of the base with the
outline).
X
Y
Place the unit over each secured wedge anchor.
X
Z
Once the pedestal legs are lined up with the wedge anchors, gently
lower the unit down (Figure 31).
X
[
Firmly press the unit onto the wedge anchors to finish the
installation.
Figure 31.
Pedestal Placement
It is strongly recommended that two people perform the following
steps.
Pedestal Leg
Wedge
Anchor
Bathtub
Figure 32.
Pedestal Placement
Silicone
Cleaning and maintenance
Leak Test
After the bathtub has been installed in its permanent location, perform the Final Leak Test. Fill the bathtub to the
overflow level and let it sit for twenty-four hours. If water has splashed onto the outside of the bathtub, dry it before
letting it sit.
Observe all connections for leakage once the water has been turned ON. If leakage does occur, turn off the water
immediately and retighten all fittings.
After twenty-four hours, if there is no water leakage, remove the protective film that covers the bathtub surfaces.
Remove the water through the drain and clean the bathtub according to the cleaning instructions in the "Maintenance"
section.
Do not use corrosives, such as paint thinner or acetone, to clean the bathtub or remove stains. Irreparable
damage to the bathtub finish will occur.
Always clean your bathtub immediately after use. This makes it easier to clean and provides best results. Use a soft
cotton cloth with a mild soap. Harsh or abrasive cleaners can harm the bathtub finish.
Use soap to clean the bathtub and never use a harsh or abrasive cleaner. Soap is effective to clean the bathtub
and it does not harm the bathtub finish.
Finish Repair
To repair a mild scratch to the bathtub finish, use the following methods to remedy it:
X
X
Polish the surface of the scratch with a metal or car polish to work up the bright surface.
X
Y
Use a 1000 grit sand paper to polish the surface of the scratch. If necessary, repeat Step 1.
X
\
Apply a bead of silicone (commercially available) around the
edge of the pedestal base (Figure 32). Follow manufacturer's
recommended drying time before proceeding.
Once the bath tub has been secured, all finish plumbing must
be installed. Please refer to the installation instructions that are
included in the packaging.
When complete, please proceed to the "Leak Test" section below.