![background image](http://html1.mh-extra.com/html/jacuzzi/era-series/era-series_installation-and-operation-instructions-manual_3299788008.webp)
Era™ Freestanding Bath
Era™ Freestanding Bath
Page 8
www.jacuzzi.com
Installation and Operation
English
Era™ Freestanding Bath
Step 3
Figure 3.
Mounting Hole Mark
Notch Cutout
Pencil
Step 2
X
X
Place the Slipper bathtub in the pre-determined permanent location.
X
Y
Using a pencil, mark on the ground where the notch cutout is on the
inside of each claw foot (Figure 3). This will be where the mounting hole
will be drilled in the floor. Repeat this step for the remaining locations.
X
Z
With the help of an assistant, gently lift the Slipper bathtub and place it
to the side.
X
X
At each marked location, drill a " hole 1½" in depth.
X
Y
Repeat this step for the remaining locations.
X
Z
When complete, clean the drilled hole of all debris.
X
[
Insert the anchor into the drilled hole. If necessary, use a hammer and
gently tap the anchor into place until it is level with the floor.
X
\
Thread the shaft into the anchor. If needed, a screwdriver maybe used.
Leave ⅜" of the shaft exposed (Figure 4).
X
]
Repeat the previous two steps for the remaining locations.
716
Shaft
Anchor
Figure 4.
Drilling Hole Mark
Step 4
⅜"
X
X
Lift the Slipper bathtub, with legs attached.
X
Y
Slowly lower the unit down onto the ground, making sure that the
shafts and notch cutouts align properly (Figure 5).
It is strongly recommended that two people perform the following
steps.
Figure 5.
Anchoring the Slipper Bathtub
Level Adjustment
Use of a level will be needed to verify that the bathtub is level. If the
bathtub is not level, please perform the following steps.
To level the bathtub:
X
X
Use an Allen wrench (supplied) and loosen the level adjustment
bolts (Figure 6).
X
Y
Adjust the bathtub to the desired levelness.
X
Z
Retighten the level adjustment bolts.
Figure 6.
Level Adjustment
Tighten
Loosen
Level Adjustment
Bolts
DOWN
UP
Level Adjustment
Bolts
Once the bath tub has been secured, all finish plumbing must be
installed. Please refer to the installation instructions that are included in
the packaging.
When complete, please proceed to the "Leak Test" section.
Shaft
Notch Cutout