Jacuzzi DELFI PRO, Руководство по установке

Страница: 29 / 80

29
- temperature between 6 and 9 ° C (42 - 48 °F): every 15 minutes
- temperatures at or below 6 ° C (42 °F): continuous
NOTES
- If the temperature of the compartment drops rapidly, the frequen-
cy of activation increases.
- If it becomes necessary to turn on the anti-freeze protection du-
ring the filtering or rapid filtering (“Istant Clear”) cycles, those cycles
will be suspended and they will resume when the anti-freeze cycle
is complete.
- If this protection is active, the spotlight may still be turned on.
”Energy savings” mode
When this function is set, the electric heater is not turned on until the
water temperature drops at least 10 °C (18 °F) below the set point.
X Press the
“Econo”
key. The display shows the message
Edx
, where “x” indicates the duration in hours .
X Use the “
Up
” and/or “
Down
” keys to enter the desired
duration, from a minimum of 0 to a maximum of 24, which means
the function is always on .
X Press the
“Econo”
key again to confirm the selected value.
You will then go to the start time (
Es
).
X
First set the hour and confirm with the
“Econo”
key. Then set
the minutes, and press the
“Econo”
key again to memorize the
set values and exit programming.
When the function is on, the display will shown the respective
symbol.
X To deactivate the function, set the duration time to 0 (zero).
NOTES
- If a function is turned on (except for the spotlight and/or the time)
when energy savings is present, energy savings is suspended, and
the symbol on the display flashes. It restarts automatically 40 minu-
tes after the function that was started is turned off.
- The minimum temperature that characterizes energy savings
mode may never be less than 15 °C (59 °F) (minimum maintenance
temperature).
- If there is a power outage, the set data are stored in memory. Ho-
wever, when the power comes back on, the function does not resu-
me. Rather, it is turned on at the set start time.
In addition to the parameters “I1x” and “I2x”, there is also pa-
rameter “I3x”, the “x” default value of which is 0. Do not chan-
ge the setting; otherwise, the electric heater will be turned off.
Q
Water filtering
Water filtering is essential to keep the water clean and clear, and
to get rid of suspended particles. This cleaning is provided by the
filtering pump and the cartridge filter(s) located under the skimmer
(see the chapter “Maintenance of the cartridge filter”).
The spa is also equipped with a special kind of filtering called “In-
stant Clear”. This is instantaneous filtering, which differs from the
normal cycle due to its brief, intense duration.
General Information
Filtering occurs during a cycle that is run every 12 hours. This cycle
consists of 2 phases. Depending on the configuration of electrical
consumption limitation (see related chapter), they are divided as
follows:
5
clock filtering cycle
pump 1
adjustment
temperature
pump 2
heating
blower
saving
energy
spotlight panel lock