Jacuzzi DELFI PRO, Руководство по установке

Страница: 31 / 80

31
Q
Blower activation
(air compressor, optional)
X Press the key “
Blower
” to activate the air compressor (the
LED comes on).
X
The blower can be activated simultaneously, or separately,
from the hydromassage pump (when the system comes on, the
blower is always off).
X
The blower stays on for 20 minutes. It can be shut off before
that by pressing the key again.
X
If you want to use the blowers for aroma therapy, insert the
perfume cartridge in the compartment located under the cover;
Once this cartridge is finished, it can be replaced with a new one
(cartridges are available from authorised dealers and technical ser-
vice centres Jacuzzi®
.
CAUTION: Replace used cartridges when the blower is off.)
NOTE
- Activating the blower and the hydromassage pumps at the same
time turns the heater off, if it is on.
- When the blower is started, the filtering pump is also turned on, if
it was not already. It will remain on for 10 minutes after the device
is turned off.
Q
Activation of the spotlight
X Press the key
“Light”
to activate the spotlight located on
the wall of the tub (the LED comes on).
X The spotlight will stay on for two hours, but it can be turned
off before that by pressing the key again. Refer to the user’s ma-
nual for the operation of the various sequences of colours.
NOTE
: when you turn on the spotlight, the filtering pump is also
turned on, as there is probably someone in the tub. It stays on for 10
minutes after the device is turned off.
Utility functions
Q
Control panel lock
There are two modes for this function:
- Partial lock: this makes it impossible to programme the filtering
cycle or change the water heating set point. You also cannot activate
the energy savings mode (Econo) or rapid filtering (“Instant Clear”).
All other control panel keys remain active.
- Total lock: this mode prevents operation.
Partial lock
To activate this function:
X
Press and hold the
“Econo”
key for a few seconds. The
symbol for the locked panel will flash on the display ( ). Continue
holding the key until the message
“LocP”
appears and the symbol
stays on steady, which indicates that the lock has been activated.
X
If you press a key whose use is not permitted, the display will
show the message
“LocP”
for five seconds.
Total lock
To activate this function:
X Press and hold the
“Econo”
key for a few seconds. The
symbol for the locked panel will flash on the display ( ). Con-
tinue holding the key even after the message
“LocP”
appears,
until the message
“LocF”
appears. The function is now active.
X
If you press a key whose use is not permitted, the display will
show the message
“LocF”
for five seconds.
De-activating the lock
X
In both modes, to de-activate the lock, press and hold the
“Econo”
key until the message
“LocP”
or
“LocF”
disappears
and is replaced by the message
“ULoc”
.
NOTES
- If their is a power outage, the keyboard lock (either partial or total)
is removed.
- If you want to change from partial lock to total lock (or vice-versa), you
must first deactivate the current lock and then set the new lock mode.
Q
Temporary shutdown of system (stand-by)
This function lets you suspend operation of all system devices for a
period of
60 minutes
(this value cannot be changed) so that you
can perform routine maintenance without having to disconnect
the power supply.
CAUTION
If you need to access the electronic parts, parts that are
normally powered, or the rotating parts of the pumps,
you must disconnect the electric power by turning off
the all-pole circuit breaker.