Unpacking
1.
Read disclaimer for shipping damages on side of
crate.
2.
Remove sides and top of crate, as well as plastic
bags, leaving pallet intact.
3.
Check for shipping damage.
4.
Remove and set aside unattached accessory pieces.
5.
Move spa to final site with pallet still attached as
shown.
6.
Place a 4 x 4 x 72" wooden block beside the pan side
of the spa so it is parallel with the pallet.
Installation Instructions
Check for shipping damage upon receipt of the spa. Jacuzzi Whirlpool Bath is not responsible for damage to the spa
sustained during shipping. If damage is evident before unpacking, see instructions regarding shipping claims on the outside
of the carton and immediately file a claim with the carrier.
Once the spa has been removed from the carton and before it is permanently installed (see below on this page for
unpacking instructions), check the spa completely for damage. Fill the shell with water and operate the system (see
Operating Instructions) to check for leaks which have resulted from shipping or handling. All Jacuzzi Whirlpool Bath spas
are factory tested for proper operation and water tight connections prior to shipping. If leaks or other problems are detected,
immediately notify your Jacuzzi Whirlpool Bath dealer or Authorized Service Agent, or call Jacuzzi Whirlpool Bath, (510)
938-7070 or (510) 938-7411 for Warranty Service.
Note: Damage or defects which could have been discovered and repaired prior to installation and which are
claimed after final installation of the spa, are excluded from our warranty.
Inspection and Shipping Claims
3
REMOVE
BOLTS
4" X 4" X 72"
BLOCK
PAN
PALLET
PALLET
SKIRT
7.
Tip the spa over onto its bottom with the block
supporting the spa.
8.
Remove the bolts and brackets securing the pallet to
the pan and spa.
9.
Remove the pallet and the 4 x 4 block, then carefully
lower the spa to a horizontal position.
10. Attach the loose skirt panel included in skirt package.
11. Record the spa serial number on the inside front
cover of this manual. (See illustration on page 2 for
the serial number location.)
CAUTION: DO NOT CUT OR REMOVE THE BOLTS
THAT SECURE THE PALLET TO THE SPA UNTIL
AFTER THE SPA HAS BEEN TIPPED OVER.
INSTALLATION
