2
ASSEMBLY INSTRUCTIONS
Loosen the set screw (1) pre-assembled to the
spout (2), rotate the spout (2) about 90° to align
handle (3), then tighten the screw.
Place the escutcheon (1) over the standpipe (2)
and then push it to the base.
2
3
1
2
Drill a hole min 2 1/4 in. diameter-max 2 9/16 in.
diameter in the floor with an electric drill (1). Mark
the locations for the screws with a pencil (2). Then
drill three holes 1/4 in. diameter for the screws in
the floor with an electric drill (1).
Floor
Floor
1/4 in. dia.
1
1
2
3
2
2
1
Attach the mixer (1) to the standpipe (2), make sure
the prongs (3) on the standpipe (2) insert into the
hole (4) of the mixer (1). Install the set screw (5) and
tighten into the standpipe (2) with hex wrench.
Note: Do not to reverse the cold and hot supply lines.
Place the assembly with the flexible supply lines (1)
through the prepared hole and then holding the
escutcheon (2), secure the standpipe (3).
Note: If mounting into wooden floor, secure the
standpipe (3) using screws (4) only (wall plugs are
not needed). If mounting into solid floor, mark the
position of holes first and then secure the standpipe
(3) using anchors (5) and screws (4). Where requried
ensure correct anchors for your floor type are used.
4
3
2
Front
Cold inlet supply line
Hot inlet supply line
1
3
4
5
5
1
2
5
3
4
6
1
2
4
3
Connect one end of the shower hose (1) to the mixer
(2) and the other end to the hand shower (3). Ensure
the washer (4) is in each end for seal.
4
