3
ASSEMBLY INSTRUCTIONS
8
Place the handle assembly (1) onto the right (cold)
valve (2). Then thread the handle seat (3) onto the
flange (4). Place the set screw (5) into handle
assembly (1) and tighten set screw (5) with Allen
wrench (Hex: 2.5mm, 6), Place the other handle
assembly onto the left (hot) valve and install the
same way.
7
Turn on hot and cold water supplies and flush water
lines for one minute. After flushing,turn the handles
all the way off to shut off the water.
10
Connect a 1/2 in. IPS faucet connector (not included)
to the water supplies underneath the sink using
wrenches (not included).
NOTE: Refer to the local plumbing codes for
permissible types of water supply connectors.
9
2
1
3
2
5
1
4
6
1
2
3
4
Connect the flexible water supply hose (1) to the
bottom of valve bodies (2) as show. Align middle
body (3) in a position which will allow maximum
clearance to connect hoses. Carefully bend the
hoses to fit available space. Carefully thread the hose
couplings to the sides of the middle body (3). Tighten
nut (4) securely with wrench.
QD86000
