![background image](http://html1.mh-extra.com/html/jacto/pj-16/pj-16_operators-manual_3199295010.webp)
10/53
5.1. Troubleshooting
•
Put about 2 liters of water in the tank.
•
While operating the lever, look into the tank to see how the
problem arises.
•
Refer to the table and diagram below.
5. Information Needed by User
DESCRIPTION
CAUSES
CORRECTIONS
Leakage through the cylinder upper part.
Worn or dried out
piston cup.
Replace or lubricate
the pump.
After pumping and
pressurizing the chamber, as you operate the
lever it drops fast.
Cylinder valve
not sealing properly
due to wear or impurities.
Clean or replace
the valve.
After pumping and
pressurizing the chamber, the lever rises
quickly when released.
Chamber valve
not sealing properly
due to wear or impurities.
Clean or replace
the valve.
5.2. Maintenance of the product
Every 40 hours, clean the chamber and lubricate all the com-
ponents. Use a pliers to disassemble the parts and a brush with
nylon bristles clean and neutral detergent. Always use personal
protective equipment (PPE).
5.3. Cleaning the sprayer
After finishing the spray application, clean and wash all equip-
ment in an approved decontamination area.
Operate the lever for the internal cleaning of the camera.
Lubricate the parts according to the image below
Remove the chamber and lubricate the piston.
5.4. Drainage
You must drain it when you finish the use.
5.5. The consequences of improper service
Do not change the sprayer components. Always check for leaks
or malfunction. Follow the maintenance instructions and use
original parts provided by Jacto.
Failure to follow the instructions may cause damage to the oper-
ator’s health and the environment.
Clean nozzles and filters
Clean nozzles with brush
5.5a. In case of clogged nozzle
Do not use metal instruments. Use a brush with nylon bristles
clean and neutral detergent.
5.6. Cylinder maintenance
DISASSEMBLING
•
Remove the chamber from the cylinder.
•
Remove the nuts (1) from the cylinder.