32
OPERATION AND ADJUSTMENTS
- Hold the chemical container over the rinse nozzle and pull the directional
valve lever to wash inside the container.
NOTE: With the chemical container over the rinse nozzle, make circular
movements to reach all internal walls of the chemical container with the water jet for
around 30 seconds.
- Fill up the sprayer tank with water.
ATTENTION: Never pull the directional valve without the chemical container over the container
rinse nozzle.
- After rinsing the chemical container, wash it for the last time,
using clean water from the 150-liter tank.
chemical
container
chemical
container
rinse nozzle
directional valve
lever
- Fit the container cap and tight it very well to avoid leakage
during the agitation.
- Agitate the container strongly in all ways (horizontal and
vertical), during approximately 30 seconds to remove the residues
that are sticked to the container internal walls.
-Take the container cap off and carefully pour the rinse water
into the spray tank.
- Keep holding the container over the spray tank opening
until the last drop.
- Repeat this operation twice more, thus completing the
triple wash.
- Next , make the container useless by piercing it. Make sure
their labels are not damaged for identification
NOTE:
To keep from contaminating the water and the clean water tank tap
during the filling of the chemical container, hold the container at least 5 cm away
from the tap and fill the chemical container with water up to 1/4, as shown.
CONTAINER RINSE
5 cm
1/4
Содержание CONDOR B-12
Страница 2: ......
