Jacobsen LDEA130, Инструкция по безопасности и эксплуатации/Руководство по техническому обслуживанию и запасным частям

Страница: 27 / 118

GB-25
RANSOMES MASTIFF 91
SAFETY, OPERATORS, MAINTENANCE AND PARTS MANUAL
Fig.38
Fig.39
Fig.40
REMOVING THE CUTTING CYLINDER
AND BOTTOM BLADE ASSEMBLY
(FIG. 38)
1. Remove the chaincase and the cylinder
drive chain.
2. Tilt the machine back until it rests on the
handles.
3. Remove the front roll by extracting the pivot
studs (A) and adjusting bolts (B) from both
sides of the machine.
4. Remove the three cylinder housing screws
(C) from both sides of the machine.
The complete cutting unit will then slide out. Re-
assemble in reverse order.
REMOVING THE LANDROLL
ASSEMBLY (FIG. 38)
1. Places wedges under the side frames for
support.
2. Remove the chain cover and landroll drive
chain.
3. Disconnect brake cable by removing the
split
pin and pin which connects the lower
end of the cable to the brake lever.
4. Remove the bolts securing the landroll
bearing housings (D) at both sides of the
machine.
The landroll assembly will then slide out.
Re-assemble in reverse order.
BALANCE BAR (PEDESTRIAN
MACHINES ONLY)
When the machine is used without the grassbox
fitted, the balance bar (Fig. 39), fitted at the base
of the handle, must be removed and fitted to the
grassbox arms.
SEAT (FIG. 40)
The seat is adjustable forwards or backwards.
(a) Release setscrews underneath mounting
and slide seat to required position.
(b) Retighten screws after adjusting.