Jacobsen G-Plex III, Инструкция по безопасности и эксплуатации

Страница: 29 / 76

GB-27
GB
JACOBSEN G-PLEX III Series: DN & DP
SAFETY AND OPERATORS MANUAL
10 LUBRICATION & MAINTENANCE
10.51 FUEL RECOMMENDATIONS - GASOLINE
Fuel tank should be filled to within 1/2, (13mm)
below the bottom of the filler neck. DO NOT overfill
the tank.
Unleaded gasoline 87 Octane or higher
We DO NOT recommend the use of ALCOHOL
bearing fuels in any of our products. The use of
these fuels may create a potential safety hazard.
NOTE: The use of alcohol bearing fuels can cause
engine malfunction, particularly "vapor
lock" at temperatures above 50° F
(10°c C).
Gasoline containing ALCOHOL can cause
deteration of some non-metalic materials
in the fuel system.
Fuel hoses must be inspected frequently
and replaced if excessive stiffness,
deterioration or fuel leakage is found.
Gasoline Containing ALCOHOL will
attract and hold moisture inside fuel
tanks. Moisture may cause corrosion of
metalic parts within the fuel system.
Fuel leakage from a fuel system can
occur while the system is in use, in
transit, or in starage. Such leakage can
contribute to an explosion or fire, causing
serious bodily injury or death.
WARNING
NOTE
• NEVER use No. 2D at temperatures below
20°F (-7°C) unless you are sure it has
been “winterized”. Cold temperatures will
cause fuel to thicken which may keep your
engine from running.
• If No. 1D is not available, a “winterized”
blend of No. 1D and No. 2D may be
available. This blended fuel is usually
called No. 2D also and may be used in
colder temperatures.
• If the vehicle fuel tank is being filled for the
first time or if the vehicle was allowed to
run out of fuel, it will be necessary to
bleed the air from the fuel system (refer to
“Bleeding The Fuel System" in the
Maintenance manual ).
10.5 FUEL RECOMMENDATIONS - DIESEL
Fuel tank should be filled to within 1/2", (13mm)
below the bottom of the filler neck. DO NOT overfill
the tank.
Use #2 diesel fuel (ASTM No. 2D) when temperature
is above 20°F (-7°C).
Use #1 diesel fuel (ASTM No. 1D) when temperature
is 20°F (-7°C) or below.