en-54
7 OPERATION
7.4
FITTING CUTTING UNIT _____________________________________________
Cutting Unit Mounting
1. Start the engine and lower the lift arms, stop engine and remove ignition key.
2. Position cutting unit under lift arm. Apply thin coating of grease to shaft and slide yoke onto shaft in direction
A.
3. Fit retainer (B) to shaft and insert bolt (C) through retainer and shaft, fit nut (D).
4. Fit retainer plate (E) and secure with screws and nuts (F)
5. Fit chain (G) to clevis on rear of cutting unit using pin (H)
and ‘R’ clip (J).
Hydraulic Motor Mounting
1.
Lubricate the motor and reel splines with Shell Gadus
S2 Grease or equivalent.
2.
Assemble hydraulic motor (K) to bearing housing,
secure with nuts (L) and washers (M) to studs.
E
F
A
B
C
D
G
J
H
K
M
L
