en-12
3 SAFETY
3.1.4 ROPS _____________________________________________________________
a
The ROPS is a safety device. Keep the ROPS in the vertical and locked position. Always use the seat belt
when you operate the mower. Make sure the seat belt can be released quickly in an emergency.
b
Only operate the mower with the ROPS in the folded position on flat and level surfaces when necessary.
Do not operate the mower with the ROPS in the folded position on slopes, near sharp edges or near water.
On a ROPS machine there is no roll over protection with the ROPS in the folded position.
c
Check for clearance before you drive below objects. Do not contact tree branches, electrical wires or other
objects with the ROPS.
d
Do not use the seat belt with the ROPS in the folded position.
e
Inspect the ROPS for damage. Keep hardware fastened.
f
Do not weld, drill, change or bend the structure. Replace a damaged ROPS. Do not try to correct a
damaged ROPS frame.
g
Do not remove the ROPS from the mower other than for maintenance access. Ensure to refit before use.
h
Jacobsen must approve any changes to the ROPS.
3.1.5 SAFE HANDLING OF FUELS __________________________________________
a
The fuel and the fuel vapors are flammable. Use caution when you add the fuel to the mower. The fuel
vapors can cause an explosion.
b
Never use the containers that are not approved to keep or transfer fuel.
c
Never keep the mower or fuel containers near an open flame or any device that can cause the ignition of
fuel or fuel vapors.
d
Never fill the fuel containers inside a vehicle or on a truck or trailer with a plastic liner. Always put the fuel
container on the ground away from your vehicle before you fill the container.
e
Refuel the mower before you start the engine. When the engine is in operation or while the engine is hot,
never remove the fuel cap or add fuel to the mower.
f
Refuel outdoors only and do not smoke when you add fuel. Extinguish all types of ignition.
g
The fuel nozzle must touch the rim of the fuel tank when you add fuel to the mower. Do not use a device to
lock the fuel nozzle in the open position.
h
Do not over fill the fuel tank. Leave at least 1 inch (25 mm) below the filler neck.
i
Always tighten the fuel tank cap and container cap after you add fuel.
j
If the fuel spills on your clothing, change your clothing immediately.
3.1.6 MAINTENANCE AND STORAGE________________________________________
a
Before you clean, adjust or repair this equipment, push PTO switch to the OFF position, lower the cutting
unit to the ground, engage the park brake, stop the engine and remove the key.
b
Make sure the mower is parked on a solid and level surface.
c
Never work on a mower that is lifted only by a Jack. Always use Axle stands.
d
Never allow persons to service the mower or its attachments without correct instructions.
e
When the mower is parked, put into storage or left without an operator, lower the cutting device unless a
positive mechanical lock is used.
- Do not keep fuel near flames or drain the fuel inside a building.
f
Disconnect the battery before you service the mower. Always disconnect the negative battery cable before
the positive battery cable. Always connect the positive battery cable before the negative battery cable.
