Jacobsen AR-522 jossa ROPS, Руководство дилера

Страница: 10 / 46

3 SET-UP
en-10
3 Set-up
3.1 GENERAL________________________________________________________________
The set-up and testing of the unit should always be
performed by a trained technician, familiar with the
operation of this equipment.
Read each instruction completely and make sure you
understand it before proceeding with the assembly. Stay
alert for potential hazards and obey all safety precautions.
The RIGHT and LEFT, FRONT and REAR of the machine
are referenced from the operator’s seat, facing forward.
Accessories not included with this product must be ordered
separately. See instructions provided with accessory for
installation and parts.
3.2 INITIAL INSPECTION _____________________________________________________________
1. Perform a visual inspection of the entire unit, look for
signs of wear, loose hardware, and components that
may have been damaged during transport.
2. Inspect paint and decals for damage or scratches.
Decals provide important operaing and safety
information. Replace all missing or hard to read decals.
3. All fluids must be at the full level mark with engine cold.
Check :
a. Radiator coolant level.
b. Engine oil level.
c.
Hydraulic fluid level.
4. Make sure air filter connections are tight and cover is
securely in place.
5. Check tires for proper inflation. Tires have been over
inflated for transport. Correct tire pressure should be
set to:
Front ......................... 16 psi (111 kPa)
Rear.......................... 12 psi (86 kPa)
6. Check belt tension.
[
Section 4.3]
7. Inspect battery connections and electrolyte level.
Check that battery is fully charged.
8. Check for fuel or oil leaks.
9. Inspect lube points on decks and mower for proper
lubrication.
[Section 6.1]
CAUTION
Do not attempt to drive the mower unless you are familiar
with this type of equipment and know how to operate all
controls correctly.
!
CAUTION
The initial inspection should be performed only when the engine is off and all fluids are cold. Lower mowers to the ground,
engage the parking brake, Stop engine and remove ignition key.
!