Jacobsen AR 250 Turbo, Руководство по безопасности и эксплуатации

Страница: 17 / 72

GB-15
JACOBSEN AR250 Series CE
SAFETY AND OPERATORS MANUAL
6.11 UNIT TRANSPORT STOP
Depressing the pedal (A) while lifting the cutting
units allows the cutting units to be raised for ma-
chine transport.
6.12 INSTRUMENT PANEL
A.
ENGINE PREHEAT INDICATOR LAMP
Colour green, on when the ignition switch is turned
clockwise to the pre-heat position. Once the lamp
goes out the engine can be started.
B. ENGINE TEMPARATURE GUAGE
Indicates current temparature of engine, whilst
running.
C. HYDRAULIC OIL WARNING LAMP
Colour red, on when the hydraulic oil temperature
reaches a preset level. If the lamp comes on bring the
machine to a stop, disengage the cutting units, apply
the parking brake and stop the engine.
D. CHARGING WARNING LAMP
Colour red, on when ignition is switched on and will go out
when the engine is started. If the light comes on while
the engine is running, the fan belt may be slipping or
broken or a fault in the electrical system is indicated and
should be investigated.
STOP IMMEDIATELY .
E. ENGINE OIL PRESSURE WARNING LAMP
Colour red, on when the ignition is switched on, and will
go out once the engine has started. If the light comes on
while the engine is running -
STOP IMMEDIATELY as
this indicates that the engine oil pressure is too low.
Check the level of oil in the sump and top up as
necessary. Check the oil pressure sender switch.
Continued operation may cause extensive damage to the
engine.
F. FUEL GUAGE
Located to the left of the engine temparature guage.
Monitors fuel level.
6 CONTROLS