Jacobsen 69168 - Turfcat T628D, Инструкция по безопасности и эксплуатации

Страница: 11 / 59

INITIAL INSPECTION 3
en-10
3 INITIAL INSPECTION
3.1 GENERAL ________________________________________________________________
The inspection and testing of the unit should always be
performed by a trained technician, familiar with the
operation of this equipment.
Read each instruction completely and make sure you
understand it before proceeding. Stay alert for potential
hazards and obey all safety precautions.
The RIGHT and LEFT, FRONT, and REAR of the
machine are referenced from the operator’s seat, facing
forward.
Accessories not included with this product must be
ordered separately. See instructions provided with
accessory for installation and parts.
3.2 INITIAL INSPECTION _______________________________________________________
1. Perform a visual inspection of the entire unit. Look for
signs of wear, loose hardware, and components that
may have been damaged during transport.
2. Inspect paint and decals for damage or scratches.
Decals provide important operating and safety
information. Notify dealer, and replace all missing,
damaged, or hard to read decals.
3. All fluids must be at the full level mark with engine
cold.
Check:
a. Radiator coolant level
b. Engine oil level
c. Hydraulic fluid level
4. Make sure air filter connections are tight and cover
is securely in place.
5. Check tires for proper inflation. Tires have been
over inflated for transport. Correct tire pressure
should be set to 14 psi (1 BAR)
6. Check belt tension.
7. Inspect battery connections and electrolyte level.
Check that battery is fully charged.
8. Check for fuel or oil leaks.
9. Inspect lube points on deck and mower for proper
lubrication.
[Parts & Maintenance Manual]
CAUTION
Do not attempt to drive the mower unless you are
familiar with this type of equipment and know how to
operate all controls correctly.
!
CAUTION
The initial inspection should be performed only when the engine is off and all fluids are cold. Lower mowers to the
ground, engage the parking brake, stop engine, and remove ignition key.
!