Jackson 10 Series, Инструкция по установке, эксплуатации и обслуживанию, Страница: 42 / 78

07610-002-41-09-F
35
PROBLEM POSSIBLE CAUSE REMEDY
Rinse does not work when
manual rinse fi ll switch oper-
ated, but does work during
automatic cycle.
1. Normally open contact on rinse
fi ll switch faulty.
2. Wire connection poor.
1. See page 22.
2. Correct the connection.
Wash does not work on
automatic cycle, but does on
manual wash.
1. Normally closed contacts on
wash switch faulty.
2. Wire connections poor.
3. Timer rinse or wash
microswitch faulty.
1. See page 22.
2. Correct the connection.
3. See page 19.
Wash does not work when
manual wash switch operat-
ed, but does work during the
automatic cycle.
1. Normally open contact on wash
switch faulty.
2. Wire connection poor.
1. See page 22.
2. Correct the connection.
When master switch is turned
on either it washes continu-
ously or rinses continuously.
1. Timer motor faulty and cams
are not turning holding it in the
mode it is in.
1. See page 19.
Wash tub water level
continuously lowers.
1. Large over fl ow strainer not
seated properly.
2. O-ring in drain fi tting is missing.
3. Deposit build up on drain fi tting
or O-ring.
4. Bottom of over fl ow strainer
(conical end of tube) bent out
of shape.
1. Remove and insert with a slight twisting action.
2. Replace. See illustration on page 49.
3. Clean.
4. Replace strainer.
COMMON PROBLEMS
TROUBLESHOOTING