Jackson 10 Series, Инструкция по установке, эксплуатации и обслуживанию, Страница: 15 / 78

07610-002-41-09-F
8
INSTRUCTIONS
INSTALLATION
INSTALLING THE
HOOD ASSEMBLY
ALIGNING THE
MACHINE
INSTALLING THE
INTERNAL VACUUM
BREAKER
Adjust the machine base to align hole in table
with hole in support block (Fig. 10).
Insert internal vacuum breaker pipe into hood
support block pin end down (Fig.11).
WARNING: Internal vacuum
breaker pipe must be installed
or there will be a hazard to the
operator.
Make sure there are two “O-rings” (Fig. 3) on the
lower support pipe near the end of the ring. While
also holding the internal vacuum breaker, lift the
hood and hood support pipe up over table. Set
hood support pipe down into the support block
hole (Fig. 12) and begin to work the hex nut into
the hole. The locating pin in the support block
will ensure proper alignment. While holding
the support pipe, start tightening nut by hand
to prevent cross-threading (it should tighten
considerably by hand), then continue tightening with a wrench. It may be necessary to
work support pipe back and forth to seat nut properly. When the nut is tight, it should
force
fl at the stainless steel and rubber washers tight to the table top.
Attach vacuum breaker support pipe clamp (Fig.
13) to the support pipe and external vacuum
breaker piping. Slide up about 12” from the
table and tighten securely. Position cover plate
(supplied with table) over square cutout in
backsplash on table so that it
fi ts tightly around
piping then snap in the four nylon fasteners
(supplied) to hold in place.
Rotate the hood to ensure it is free. If not, check level of machine, tightness of table
to machine
fl ange, centering of machine, level of table, and hood support pipe.
(Fig. 10)
(Fig. 11)
(Fig. 12)
(Fig. 13)