FAN Selection
FAN
Auto
On
Press the
key to cycle through the fan selections. More details on fan functions can be found on
page 20 of this manual.
The HVAC system fan will only run with a call for heating or cooling.
The HVAC system fan will run continuously.
MODE
O/RIDE
PROG
FAN
Cool
Heat
Setting the clock
PROG
PROG
PROG
PROG
The T-32-P has a real-time clock that is used for
programming functions. It is important that the time
and day of week be set properly so that programmed
events run correctly.
To set the clock, press the
key until the hour
flashes on the LCD. Use the up ( ) or down ( ) key to
set the current hour along with the AM and PM
symbol. Press the
key again until the minutes
flash. Use the up ( ) or down ( ) key to set the
current minutes. Press the
key again until the
day flashes. Use the up ( ) or down ( ) key to set the
correct day of the week. Press the
again to
exit the clock and day of week program.
PROG
KEY
UP / DOWN
KEYS
Start
Programming 2 daily events
Start
Stop Start
Stop
The commercial programmable mode provides 2 schedules per day using a separate heating and
cooling setpoint. The schedule is shown on the LCD as
and
.
represents the
occupied mode and
represents the unoccupied mode. Programming steps are the same as a
residential program other than there are only two events per day rather than four.
MODE
O/RIDE
PROG
FAN
Cool
Heat
PROG
KEY
Entering the program mode
PROG
Start
MON
PROG
PROG
Hold the
key down for 3 seconds.
The display will show
(occupied) and the day
will flash.
Use the up ( ) or down ( ) key to set the day you
wish to start programming.
Press the
key again and the hour will flash.
Use the up ( ) or down ( ) key to set the hour you
wish the program to start. Make sure that the AM /
PM is correct.
Press the
key again and the minutes will flash.
Use the up ( ) or down ( ) key to set the minutes for
the program to start.
UP / DOWN
KEYS
Start
6