The LCD will now flash the current program number to remind you that an override is in progress. The
override temperature settings will remain in effect until the override time expires or until the next
scheduled event (whichever comes first). You can return to the programmed schedule at any time by
pressing the
key and then pressing it again. The program number will stop flashing
confirming that the T-32-P is now running the programmed schedule.
Press the
key. The LCD will show the word
. The current programmed heating and
cooling temperatures will be held permanently or can be adjusted by pressing the up ( ) or down ( )
key which will display the current program temperature along with the word
. Press the up ( ) or
down ( ) key to change the temperature.
To return to the programmed schedule, press the
key until the word
is no longer
displayed.
Your can review the set temperatures at any time by simply pressing the up ( ) or down ( ) key.
O/RIDE
Permanent Temperature Hold
O/RIDE
SET
O/RIDE
Reviewing Set Temperatures
HOLD
HOLD
Default Schedule
Setpoint (Mon - Sun)
Schedule
Start Time
Heating
Cooling
1
6:00 AM
70
75
2
8:00 AM
62
78
3
6:00 PM
70
75
4
10:00 PM
62
78
Factory Default Schedule
Commercial Programmable Mode
MODE
O/RIDE
PROG
FAN
Cool
Heat
Start
MODE Selection
MODE
Heat
Cool
Cool
Heat
E. Heat
OFF
Press the
key to cycle through the modes of
operation and the LCD will display the following:
Heat Mod
Cool Mode
Emergency heat when T-32-P is
configured for a heat pump system
Thermostat is off
MODE KEY
FAN KEY
Auto Changeover (Installer must
activate this mode)
5