Jackson Grills LUX Series, Руководство пользователя

Страница: 10 / 61

10
Figure 10
8. The propane hose & regulator assembly must be
connected with rigid pipe, copper tube, or an
approved flexible metal connector which complies
with Z21.4/CSA 6.10.
9. The installation must comply with CAN B149.1
Natural Gas and Propane installation code in
Canada, or to the National Fuel Gas code, ANSI
Z223.1 in the United States.
10. The gas supply pipe must be sufficiently sized to
supply the BTU/h specified on the rating plate,
based on the length of the piping run.
11. If installing a side burner, a spate line must be
branched off to the side burner unit and enter the
side burner opening at the specified location.
◼
BUILT IN PROPANE CYLINDER ENCLOSURES:
1. Built in cylinder enclosures which completely
enclose the cylinder must have both of the
following:
a. At least one unobstructed ventilation opening on the exposed exterior side of the enclosure located within
5 in (127mm) of the top of the enclosure. The opening must have a total free area of more than 20 square
inches (130 cm square) for a 20lb (9.1kg) cylinder.
b. At least one ventilation opening on the exposed, exterior side of the enclosure located 1 in (25.4mm) or
less from the floor level. The opening must have total free area of more than 10 inches squared (65 cm
squared) for a 20 lb (9.1 kg) cylinder. The upper edge must be no more than 5 inches (127 mm) above the
floor level.
2. Every opening must be large enough to permit the entrance of a 1/8 inch (3.2mm) rod.
3. The cylinder valve must be readily accessible for hand operation. A door on the enclosure to gain access
to the cylinder valve is acceptable, provided it is non-locking and can be opened without the use of tools.
The cylinder valve must be visible.
4. There must be a minimum clearance of 2 inches (51mm) between the floor of the LP-gas cylinder
enclosure and the ground.
5. The enclosure must be designed so that the LP-gas cylinder can be connected, disconnected and the
connections inspected and tested outside the cylinder enclosure. Any connections that can be disturbed
when installing the cylinder in the enclosure must be accessible be for testing inside the enclosure.
◼
CARTS: INSTALLING & CONNECTING A PROPANE CYLINDER TO THE GRILL:
1. Make sure tank valve is in its full off position (turn clockwise to stop).
2. Check tank valve to ensure that is equipped with external (male) threads (i.e. QCC-1 type connecter).
3. Make sure all burner knobs are in their off position.
4. Remove the protective dust cap from the cylinder valve. Always reuse dust cap when storing a cylinder.
5. Inspect valve connection port and regulator; look for any damage or debris. Inspect hose for damage.
Never attempt to use damaged or plugged cylinders. Contact your local propane gas dealer for repair.
6. Remove the Pedestal Base Access Cover. (Fig. 8)
7. Place the Propane Tank into the Tank Mounting Hole in the pedestal of the grill. (Fig. 9). Always install the
propane cylinder in an upright position with the valve at the top, to facilitate vapor withdrawal (Fig. 9).
8. Attach the Propane Hose and Regulator by hand-tightening the black plastic Quick Coupling Connecter
(QCC) nut clockwise to a positive stop. Do not use a wrench to tighten as this may damage the nut and
cause leaks. (Fig. 10)
Figure 9
Figure 8
Tank Mounting Hole
Figure 7
Typical 20lb. Propane Cylinder Connection