22
PROBLEMS
POSSIBLE CAUSE
SOLUTIONS
Torch Light pilot
flame will not light:
Electrode contaminated w. deposits:
Use an old tooth brush, some alcohol, and emery paper
to clean electrode tip and insulator.
Electrode or wire damaged & no spark:
Replace gas valve assembly complete with wire.
Electrode wire loose or fallen off:
Reconnect electrode wire at gas valve.
Plugged Torch Light orifice or outlet tube:
Clean torch tube, and/or unplug orifice with fine wire.
Natural Gas outlet or propane tank delivering low or
no fuel:
Check Nat Gas pressure. Check propane tank empty?
Propane Safety Valve tripped (see PP 9).
Main Burner won’t
light after torchlight
lights successfully:
Burner orifices plugged/caked w. residue:
Check and clean burners and main valve orifices.
Natural Gas outlet or propane tank delivering low or
no fuel:
Check Nat Gas pressure. Check propane tank empty?
Propane Safety Valve tripped (see PP 9).
Air Shutters set incorrectly:
Re-set burner air shutters per illustration above
Burner(s) incorrectly installed and misaligned with
valve orifice:
Re-install burner(s) correctly so that the orifice is
centered in the
burner’s inlet.
Defective Gas Valve(s):
Replace gas valves as needed.
No Spark at rear
rotisserie burner:
Dead battery in rear burner ignition switch:
Replace battery by unscrewing switch cap
Defective ignition switch/module:
Replace ignition switch/module
Contaminated rotiss burner electrode
Use an old tooth brush, some alcohol, and emery paper
to clean electrode tip and insulator.
Inadequate Heat:
Defective regulator
Replace NG Regulator OR Propane Hose & Regulator
Low inlet Pressure
Check NG gas pressure, check propane tank empty?
Gas hose bent or kinked:
Smooth out the hose and check for damage
Grill not preheated:
Preheat the grill for 15 minutes, minimum
Gas valve hard to
turn:
Corrosion at valve stem:
Remove knob and lube with penetrating oil; work valve
back and forth to loosen; lube regularly.
Excessively yellow
or orange flames:
Incomplete combustion:
Re-set burner air shutters per illustration above
Grease Fire or
Excessive Flame
Flare-ups:
Excess fat on meat causes fat fire flare-ups:
Trim fat off meat before grilling (NOTE: check and empty
grease tray regularly)
Excess Grease deposits:
Regularly clean Firebox, Grease Pan, and Grease Cup
NOTE; check grease cup prior to each use of grill.
Flame lifts off burner
while in operation:
Gas pressure too high:
Call a professional gas fitter or Propane dealer
Air Shutters set incorrectly:
Re-set burner air shutters per illustration on page 20.
Knobs getting too
hot:
Wind blowing from behind the grill:
Reposition grill or create wind barrier.
Grill is not level:
Reposition grill.
Содержание JLS400-LP Lux
Страница 23: ...23 Exploded View LUX JLS700 BUILT IN Model ...
Страница 26: ...26 Exploded View LUX JLS700 CART Model ...
Страница 54: ...54 Vue éclatée LUX JLS700BI ...
Страница 57: ...57 Vue éclatée LUX JLS700 ...
