Jackson Grills JLS400-LP Lux, Руководство пользователя

Страница: 13 / 61

13
Regulator set at
4” WC (Natural
Gas)
Typical Rear gas
connection:
Typical
Bottom Gas
connection
Installer supplied
gas shutoff valve
(must be in an
accessible
location)
Installer
supplied gas
shutoff valve
(must be
easily
accessible)
Typical Natural Gas Connection
CAUTION: Provide adequate ventilation holes in the enclosure for safety
purposes in the event of a gas leak.
Figure 12
!WARNING!
1 Never insert any foreign objects in the
quick release or Natural Gas hose, as this
may cause leaks.
2 Pressure from the gas source for this grill
and its appliance regulator (set at 4” WC)
MUST NOT exceed 7 inches of Water
Column; using a grill at higher pressures
could result in property damage, and injury
or death.**
3 Do NOT use this grill until leak tests
have been completed.
4. If a gas leak is detected and cannot be
stopped, call the fire department
immediately
.
** NOTE; this is the maximum inlet
pressure rating for the included Natural
Gas Regulator, part number JF-99
4. The gas supply pipe must be sufficiently sized to supply the BTU/h specified on the rating plate, based on
the length of the piping run.
Leak Testing:
◼
GENERAL:
1. Although all gas connections on the grill are leak tested at the factory, a complete gas tightness check
must be performed at the installation site. This is mandatory due to possible mishandling during shipping
(which could loosen fittings), or excessive pressure unknowingly being applied to the unit.
2. Periodically check the whole system for leaks, or immediately check if the smell of gas is detected.
◼
BEFORE TESTING:
1. Make sure that all packing materials are removed from the grill and cart.
2. Do not smoke while leak testing.
3. Never leak test with an open flame.
4. Make a soap solution with one part dish soap and one part water. Prepare a spray bottle, brush, or rag to
apply the solution to the connections. For the initial leak test, make sure the propane cylinder is full.
5. Grill must be leak tested outdoors in well-ventilated area, away from ignition sources such as gas fired or
electrical appliances, and flammable materials.
◼
TESTING PROCEDURES:
•
Make sure all control knobs are in the “OFF” position.
•
Make sure the regulator is connected to the propane cylinder tightly. For Natural Gas, ensure that the gas
hose is correctly connected at the quick release box pre-installed on the home. (Not included with grill).
•
Completely open propane cylinder valve by turning SLOWLY counter clockwise. If you hear a “POP”
sound, turn gas off IMMEDIATELY, it indicates a heavy leak at the connection. Call your gas dealer or fire
department.
•
Check every connection from the propane cylinder or natural gas quick release, up to and including the
connection to the manifold pipe assembly (the pipe that goes to the burner) by brushing or spraying the
soapy solution on the connections.
•
If soap bubbles appear, there is a leak. Turn off propane cylinder valve or natural gas quick release
IMMEDIATELY and retighten connections, Turn on gas, and recheck for leaks.
•
Always close the propane cylinder valve and/or disconnect the Natural Gas hose, after leak test, when the
grill is not in use.
•
Only those parts recommended by the manufacturer should be used on the grill. Substitution can void the
warranty. Do not use the grill until all connections have been checked and do not leak.