8
LIGHTING INSTRUCTIONS:
1. Inspect the hose and burner for wear or damage. DO NOT LIGHT THE FIRE PIT IF DAMAGE OR WEAR IS
FOUND.
2. PROPANE: Attach the regulator assembly to your propane cylinder. NOTE: Make sure your propane cylinder
valve is closed.
3. Attach the campfire regulator assembly to your propane cylinder by
threading the black plastic QCC fitting clockwise onto the cylinder
valve until hand tight (fig 8).
4.
NATURAL GAS: check to ensure that the gas source connection is set at 7”
water column. Then, connect the natural gas hose to the pre-installed gas
connection at the natural gas source on the home.
5. When connecting the Patio Fire to a gas source for the first time, always
perform a leak test using a soap and water solution.
a) Apply the soap solution to the connections at either end of the hose and regulator assembly.
b) PROPANE: Open the LP cylinder valve; if bubbles start to form between the valve and the hose there is
a leak. Shut off the gas, then remove and reattach the hose. If bubbles continue to form indicating the
leak is still there, SHUT OFF the gas and contact the nearest dealer. If no bubbles are seen, leave the
gas on, and continue to step 6.
c) NATURAL GAS: Open the gas line valve, if bubbles start to form between the valve and the hose there is
a leak. Shut off the gas, then remove and reattach the hose. If bubbles continue to form indicating the
leak is still there, SHUT OFF the gas and contact the nearest dealer. If no bubbles are seen. Leave the
gas on, and continue to step 6.
6. Place a lit match or equivalent on the log set near a burner port (fig 10).
7. Stand clear of the burner ports, and slowly turn on the gas. (fig 9
; shows the propane valve in the “off”
position). This Patio Fire
may light with a “WOOF’; this is normal and is not dangerous.
8. The flame intensity can be lowered by slowly closing the gas valve.
9. TO SHUT OFF Patio Fire: simple turn the On/Off Valve to the off position (red arrow, fig 9). Then shut off fuel
source. Note: this unit must be shut off for 5 minutes before restart is permitted.
!WARNING!
NEVER use an open flame to check for
gas leaks; Injury, death and/or property
damage may result.
On/Off Valve
TECH TIP
To apply the soap solution
to check for leaks, use a
medium sized artist or
hobbyist type paint brush.
Fig. 8
Fig. 9
Fig. 10
