Jackle inoMIG 350, Руководство по эксплуатации

Страница: 52 / 68

inoMIG 350/400
Operating manual Page 50
34. Welding torch with Display / Job - sequence
Warning: Switch off the machine for changing the torch !!
Functions (sorted by the control box):
Hnd Cor Sol Mod Cho Sts bUb PrG PoG Job CSC CEC Spt
MC 1
■ ■ ■
*
■ ■ ■ ■ ■ ■ ■ ■ ■ ■
MC 2
■ ■ ■
*
■ ■ ■ ■ ■
* This function is active during welding!
Hnd = Hand welding, Cor = Voltage correction (Automatic welding),
Sol = Power, Mod = Mode (see below), Cho = Choke, Sts = Startspeed,
bUb = Burn back, PrG = Pre gas time, PoG = Post gas time,
Job (see below), CSC = Crater start current, CEC = Crater end current,
Spt = Spot time
(CSC and CEC only active with crater function)
Tapping on the arrow button will switch between the different functions.
The value can be changed by using the + and – buttons.
The changes are displayed simultaneously on the MC control box.
Functions with extended selections:
Function MODE (Mod):
- Mode 2-cycle / 4-cycle / spot – crater
Display ‚Mod‘
Use the - button to switch between 2-cycle (2) or 4-cycle (4) function.
(Indication in the left display 2 or 4)
Use the + button to switch between normal operation (-), spot welding (S) or crater function (C).
(Indication in the right display – or S or C)
- Mode Automatic welding or Hand welding
Display ‚Mod‘
A long press of the – button will change between Automatic (A) and Hand (H) welding.
(Indication in the middle display A or H)
Function Job:
- Calling a Single Job:
Press the arrow button repeatedly until ‘Job’ appears on the display.
Select the desired job number using the + or - button and confirm by pressing the arrow button.
The job, e.g. Nr. 2 is selected (= in display).
Comment: =
Job selected, u Job number occupied, F Job number free
- Save multiple jobs in a sequence and recall:
It is possible to store several jobs behind the other to move during the welding process between the
individual jobs back and forth. This is useful, for example, if a part must be welded with different welding
power, but the welding process should not be interrupted.
Comment: The jobs must all be of the same wire diameter and gas type.
But it is possible to use standard MIG/MAG and Power in the same sequence.
The job sequence must always be limited by a free job at the beginning and end.
Example: Job 1 – free, Job 2 - MIG 160A, Job 3 - Power 250A, Job 4 - MIG 100A, Job 5 – free
In this example, it is possible to change during welding between the welding jobs 2, 3, and 4 by
using the + and - buttons.
It is possible to store several of these job sequences.
They must always be enclosed by a free job.
To activate a job sequence, a job from this sequence must be selected and called up by pressing the
arrow key. When the display of the torch is switched back to the normal display (after 3 seconds), it is
possible to select between the jobs using the + and - button.
Attention: If there is an error in the sequence (e.g., different gases / material), the job sequence cannot
be activated.
To reset the + / - buttons for the power control during welding, open the Job menu and select a free job
e.g. (F 1) and confirm it by pressing the arrow key.
+