Jackle inoMIG 350, Руководство по эксплуатации

Страница: 50 / 68

inoMIG 350/400
Operating manual Page 48
FSt: Pulse superimposed high-arc (Fast Arc):
The FAST ARC is a modified innovative arc that has been especially developed for high welding speeds for steel
and non-ferrous metals.
By means of magnetic influences, a very narrow arc reduces the heat input into the material and therefore
reduces material distortion and rework.
The welding programs included within the scope of supply allow a high level of welding power in short and mixed
arcs.
Advantages
- high welding speed
- suitable for steel and non-ferrous metals
- virtually no welding spatter
- lower level of heat input due to a higher welding speed
- safer and deeper penetration with a higher rate of deposition
- higher welding speed in relation to normal spray arc
- saving of wage, material, gas and energy costs
- optimal side wall fusion and therefore, less undercut
- easy manipulation
Applications
- medium to heavy workpiece thicknesses
- steel, stainless steel and Aluminium processing operation
- automated and manual usability
Power range: 70A – 350/400A
Material Display MC Gas Display MC Wire diameter / mm
Steel FSt Argon 82%, CO
2
18% - MIX 18 Ar82 1,0-1,2
Metal flux-cored
wire
FnEP Argon 82%, CO
2
18% - MIX 18 Ar82 1,2
These welding processes are all synergic welding programs.
In order to facilitate operation, it is normally necessary to configure the right welding program and welding power.
All other parameters are regulated by the machine itself.
This allows operating personnel with little experience to achieve good welding results.
A variety of welding programs have already been saved in the machine.
(see program selection panel in the wire feed flap)