Plasma CUTTER 150
Operating Manual
Page 2
2. Safety Requirements
2.1 General Information’s
This welding unit has been manufactured in accordance with the relevant interna-
tional standards. However, improper use or manipulation of the machine may cause
hazards.
The following safety instructions must be strictly observed:
a) This unit is exclusively intended for the Plasma cutting process.
Cutting operations with the Plasma cutting unit should be carried
out be qualified persons. Service personnel must be duly informed of
all safety rules.
b) Electrical repair work must be carried out by qualified electricians
c) Always disconnect mains prior to servicing, maintenance, and repair
work and before opening the casing.
2.2 Electrical Information’s, Fire
The cutter must be protected against arc radiation and burning by
wearing adequate protective clothing such as a leather apron,
leather jacket, leather gloves etc.
Inflammable substances must be kept away from the welding area.
They might catch fire from sparks or hot slag.
Mains cable, hose pack, and workpiece cable must be perfectly
insulated. Any defective insulation must be repaired immediately.
