SK-947-RK-6
Remote Key with Small Barrel & 72" Cable
(Included with the SK-554NP-RKAC-4)
SKD-3840PLE
6' Dual Sensor – USB Sensor & Rectangular Sensor
SK-974AH
1/2" Dia. Barrel Sensor Adhesive
SK-395M
AC/DC Power Supply (5 volt. - 1 Amp)
with International Electrical Plug Ends
Installation Instructions for the
4-on-1 Alarm w/Remote Keyway
Rev. 3/13/13
P# 62097 SCI-9983
©2013 Se-Kure Controls,
®
Inc.
3714 Runge Street
Franklin Park, IL 60131
1-(800) 322-2435
(847) 288-1111
Fax: (847) 288-9999
On the Web:
www.se-kure.com
E-Mail:
SK-905
1" x 2" Rectangular Adhesive
SK-974PLE
6' Barrel Sensor
SK-554NP-RKAC-4
4-on-1 Alarm with No Power
1.
Mount the Remote Key
within 72" of the Alarm
Module, and plug it into the
Remote Key Jack on the
Alarm Module.
2.
Insert the key, push in and
turn clockwise. (This places
the Alarm in the “Stand-by”
position).
Note: The key can only be
removed in the “ON”
position.
3.
Insert the appropriate
adapter into the SK-395M
AC/DC power supply. Plug it
into an electrical outlet, and
the other end into the AC/DC
Power Supply Jack on the
Alarm Module.
4.
Choose a small flat area on
the product where the sensor
is to be applied.
VERY IMPORTANT! NOTE:
Clean
the area on the display product and
the sensor with Alcohol Prep Pads.
Wipe these surfaces DRY
with a
clean paper towel. If the paper
towel shows dirt,
REPEAT THIS
CLEANING STEP
until the sur-
faces are
CLEAN & DRY
!
Clean &
Wipe Dry
When replacing Adhesive
5.
Remove the sensor adhesive
from its backing sheet. Apply
the adhesive pad to the bottom
of the sensor, making sure that
the center hole of the adhesive
lines up with the plunger on the
bottom of the
sensor.
