4
4.0 - ALARM POSITIONING
5.0 - SET FUNCTIONS
The system is equipped with a “SET FUNCTIONS” which allows to program and customize
the alarm following to the user needs.
To access to the SET FUNCTIONS:
1 - The alarm must be disarmed.
2 - Switch the motor vehicle ignition on, place the GT889 handsets contacts to the receptacle
and check that 5 quick beeps are emitted and the RED LED will switch on constant. The alarm
is in SET FUNCTIONS mode.
3 - After 5 seconds starting from the function No.1a sequence of LED beeps corresponding to
the function are emitted, the LED flashes can be GREEN or RED to indicate the function state.
The sequential cycle of the LED flashes (from the function No.1 to the No.8) is repeated twice
and after you come out from the SET FUNCTION.
4 - To select a function switch on-of
f the motor vehicle in correpondance of the relative signal,
the LED illuminatesof the colour which corresponds to the function state (test excluded).
5 - Within 10 seconds change the the functio
n setting out by the OFF handset button. The
setting out change is confirmed by the change of the LED colour and by a beep. After 10
seconds, starting from the last function selected, the function sequence will start again.
The system is equipped with a “SENSOR” which allows to detect possible motor vehicle shocks/
movement. For an optimum operation pay attention to the fixing positions indicated below.
YES
YES
YES
YES
YES
HORIZONTAL PLANE
YES
YES
NO
HORIZONTAL PLANE
HORIZONTAL PLANE
NO
MAX 10°
YES
YES
WARNING:
- Before carrying out the definitive fixing it is suggested to place temporary the alarm
and check the correct operation of the shocks/movement sensor.
