GD-04K
- 14 -
MNY51104
NOTES:
GD-04K -
3
- MNY51104
All inputs have their own time filter (from 0.5 to 10 hrs)
A maximum of 30 V can be connected from an external device to the input terminals
(A – D).
Each input can have its own name. Input activation / deactivation is reported to the pre-
defined telephone numbers and also recorded in the event history. Up to 384 events
can be stored with information about input or output activation / deactivation with the
source of that event (who / what caused it).
Power terminals:
X1, X2 (RELAY X)
NO contact of the power relay, 230 V / 2.5 A.
Y1,Y2 (RELAY Y)
NO contact of the power relay, 230 V / 2.5 A.
LED indicators:
Red
indicates GSM module incoming activity
Green
indicates GSM module outgoing ac RESET indication
Common properties:
Both outputs (X and Y) can be switched ON independently for a pre-defined time in an
interval from 1 s to 10 hrs (impulse) or permanently.
Both relays are galvanically separated from the communicator circuits complying with
4kV safety isolation requirements.
3. Installation and initial setup
1. Select an appropriate place for communicator installation considering the GSM signal
strength.
2.
The communicator´s main board can be simply released by pressing the flexible tabs
(6) when you open the front cover.
3.
Attach the rear plastic part to the selected place.
4.
Put the main PCB back onto the rear plastic part.
5.
Insert the SIM card – orientation is indicated on the PCB (See also chapter 8. SIM
card and its use)
Note:
The GSM antenna mustn’t be shielded by metal objects. The original antenna
can be replaced by an external one meant for the GSM band 900/1800 MHz and
HTXLSSHGZLWKDQ60$FRQQHFWRUFRQQHFWHGE\DFRD[FDEOHZLWKDȍLPSHGDQFH
if needed.
6.
Connect the input / output and power wires to the communicator´s terminals.
Power
: Connect the supplied mains adapter to the +12 V and GND terminals (the
wire with a grey stripe is for the +12 V terminal). When another power is used, it must
provide 12 V DC and a current of at least 500 mA. Don´t turn it on yet.