Page 14
FS-450 Fuel Scan
Changing the FS-450 Set Up
You may need to change the fuel measurement units, the fuel tank
capacity, and may prefer to set your own alarm limits. Follow the
procedure outlined below to change any of the factory default
settings.
To start the Set Up procedure, after power up, wait until the
FS-450 completes its self test and is in the Automatic or Manual
indexing mode. If in doubt, tap the
STEP
button a few times. Then
follow the steps illustrated below. The display will then sequence
as shown in the chart below. Tap the
STEP
button to advance to
the next item in the list. Tap the
AUTO
button to select alternate
values of that item. Hold
AUTO
button to increase a numerical
value; tap the
AUTO
button to decrease a numerical value.
Procedure—Changing the Set Up:
Hold both
buttons for 5
seconds until
the words
Tap STEP
button until
the words
Hold both
buttons for 5
seconds until
the words
Setting Tank SIZE for the first time. Hold the STEP button in
and power up to see and set size or use procedure below.
Tap
STEP
to
next item
Hold or tap AUTO
to
sequence through these
values
Description
Selects fuel units
Hold or tap
AUTO
to
select main capacity
Main tank capacity, in units
selected
Y—Yes—aircraft has
auxiliary tanks (next step)
