J+J J4C S20, Руководство пользователя

Страница: 63 / 91

ASSEMBLY INSTRUCTIONS
HANDBOOK_
KIT DPS_
63
INDEX
14. Disconnect the grey connector from the power supply.
15. Use the configuration you need by moving the DIPs, according to the instrumentation signal
(Fig.14) :
16. Carefully mount the cover, minding the cables not to be pressed (Fig.15) .
17. Fix the cover to the body by using the 8 screws (Fig.16).
18. Mount the hand wheel on the shaft and fix it by using the screw (Fig.17).
19. Mount the 3 outer connectors together with its rubber joints and fix them to the cover, by using the
screws (Fig.18) .
20. Remove the wiring label from the actuator and replace it by the one inside the kit box (F) .
21. Fill in the document inside the kit, and send it to the fax number or e-mail, shown in the document.
The actuator is ready to work.
Outer Set-Up: Only if necessary.
- B plug - Connect a cable between PIN 1 and PIN Earth (Fig.19) .
- A plug - Connect it to the power supply.
- B plug, disconnect the cable between PIN 1 and PIN Earth.
The actuator will make a complete maneuver.
Connect and fix the B outer connector to the actuator. The actuator is ready to work.