M
AINTENANCE
Application area
Operating material
Motor lubrication
JDN high performance
grease, item no. 11904
(250ml)
Engine lubrication for
operation with oiler
Air lubricator “D”, kine-
matic viscosity about
30
mm
2
s
(cSt) bei 40
◦
C,
possibly with anti-icing
agent
Chain lubrication
Chain oil or vehi-
cle motor oil, kine-
matic viscosity
about150
mm
2
s
(cSt)
at 40
◦
C, or special
lubricant from J.D.
Neuhaus.
In areas with extreme
corrosion potential,
such as offshore, a
lubricant with a particu-
larly powerful corrosion
protection is to be
used.
Engine corrosion pro-
tection (not applicable
if using the JDN high
performance grease)
Non-gumming preser-
vative oil with corre-
sponding effective
duration
Engine cleaning (not
applicable if using the
JDN high performance
grease)
Pure petroleum
Lubrication for bearings
and gearbox (also for
open gears)
Lithium-saponified
grease, worked pen-
etration 265-295
(0,1mm), base oil
viscosity: 190
mm
2
s
(cSt)
bei 40
◦
C, dropping
point: 180
◦
C,
Application temper-
atures: -20
◦
C bis +
120
◦
C,
Designation according
to DIN 51825: KP2K-
20, active ingredients:
EP additives (to reduce
wear) and ageing pro-
tection; water-resistant
and anti-corrosive
8.6.2. Lubricating the chain
Before tests can be carried out, the chain must be
lubricated.
The chain of your product
PROFI 3 TI
must be
lubricated in the links in an unloaded state.
I
Clean heavily soiled chains.
I
Place the chain in a suitable container.
I
Spray the chain with a special lubricant or ve-
hicle engine oil.
If you want to lubricate the suspended chain, en-
sure that the chain links are oiled at the contact
points. Move the chain back and forth to do this.
During operation in areas with a high corrosion po-
tential, such as offshore, the chain can be largely
protected against corrosion by using speciality
lubricants. These types of lubricants are char-
acterised, among other things, by a weathering
resistance, water insolubility and good adhesion
properties.
The re-lubrication intervals are to be set depend-
ing on the exposure. Please contact us if neces-
sary.
Doc.-No.: VA053957-40-OM-EN-0720-60-2
Page
45
of 60
