eZ80F91 Modular Development Kit
QS004611-0810
Page 5 of 10
5. Browse to the driver directory, one of the following:
<ZDS II Installation Directory>\device drivers\USB
<ZDS II Installation CD>\Device Drivers\USB
6. Click
OK
, and then click
Next
after the appropriate driver is found.
7. Click
Finish
to complete the installation.
Connecting the USB Smart Cable to the eZ80Acclaim!
®
MDS
Adapter Board
Attach one end of the six-conductor ribbon cable (included) to the USB Smart Cable 6-pin
DBG connector. See
on page 5. Attach the free end of the ribbon cable to the
DBG connector on the eZ80Acclaim! MDS adapter board. Ensure that pin 1 on the ribbon
cable (indicated by the dark stripe) is aligned with pin 1 on the target connector.
Disconnect or turn OFF the power to the eZ80Acclaim! MDS adapter
board, before connecting or disconnecting the USB Smart Cable.
Applying Power to the Development Board
After installing the USB Smart Cable, connect the power supply to the development board
at connector J7, and then to an electrical outlet. The Green 3.3 V DC LED illuminates
indicating that power is supplied to the board.
Figure 2. Connecting the Six-Conductor Ribbon Cable to the Serial or USB Smart
Cable
Caution:
