IXXAT PC-I 04/104, Руководство по оборудованию

Страница: 11 / 16

PC-I 04/104 Manual, Version 2.7
Configuration
11
3.1.4 Providing Power Supply via CAN Connector
VCC (5 V) or GND can be connected to the 10 pin header with the soldered
jumpers JP2, JP3, JP7 and JP8. For this, the jumpers listed in the following table
must be closed. The soldered jumpers are located on the back of the PC-I
04/104 (Fig. 3-2).
Connector pin – signal Default setting X1 X2
2 - GND open JP7 JP2
8 - VCC open JP8 JP3
Caution:
This voltage may be loaded with maximum 100 mA.
With galvanically isolated bus interfaces, GND and VCC are also galvanically
isolated from the power supply of the PC.
Fig. 3-2:
Soldered jumpers of the PC-I 04/104 interface, back
3.2 Design of the CAN Connectors
Two separate high-speed bus interfaces according to ISO 11898-2 can be
mounted on the interface.
The signals of the first bus interface are connected to the 10 pin header X1. If
the second bus interface is assembled, the signals for the CAN bus of the
second bus interface are connected to the header X2.