Installation
2 Installation
2.1 Hardware installation
For all work on the PC and interface, you must be statically discharged. Work must be
carried out on an earthed, antistatic work mat.
Take the following steps in sequence:
(1)
Find a free memory segment on the PC of at least 4 kbytes in the range
< 1MB (ISA memory range) and a free IRQ for each CAN controller. Use the
manual of your PC for this.
(2)
Set this memory segment and the IRQ on the interface, as described in sec-
tion 3.1.
(3)
Switch the PC off and remove the mains plug.
(4)
Open the PC according to the instructions of the PC manufacturer and find a
suitable place to plug in. The interface is designed according to the PC stan-
dard and can easily be built into the computer. Do not use force when plug-
ging in.
(5)
Make sure the interface sits tightly in the PC.
(6)
If your interface is equipped with 2 separate CAN lines, you must fit the additional
slotplate and plug in the header on the interface (see section 3.2).
(7)
Close the PC; the hardware installation is now complete.
2.2 Software installation
A driver is required to operate the interface. For installation of the CAN driver VCI under
Windows, please refer to the VCI installation manual.
Copyright IXXAT Automation GmbH
PC-I 03 - Manual, Version 3.2
6
Содержание PC-I 03
Страница 4: ......
