Introduction
1 Introduction
1.1 Overview
Congratulations on your purchase of the IXXAT PC/CAN interface PC-I 03, a high-
quality electronic component developed and manufactured according to the lat-
est technological standards.
This manual is intended to familiarize you with your interface, also referred to in the
following as PC-I 03. Please read this manual before beginning with the installation.
The manual describes, among other things, the hardware architecture of the interface,
knowledge of which is required for creating your own drivers.
If using the interface with the IXXAT driver VCI or other IXXAT software, you do not
need to read sections 4 and 5.
1.2 Features
The main technical features are as follows:
•
8 bit AT slot interface
•
Independent operation of two separate CAN lines each with a CAN controller Philips
SJA1000 or Intel 82527 possible
•
CAN controller with 16 MHz clock
•
Each CAN controller can be allocated a separate PC interrupt line via jumper field for
connection to the PC interrupt system. The following 10 interrupt lines are available:
IRQ 3, 4, 5, 7, 9, 10, 11, 12, 14 and 15
•
Support of shared interrupts
•
Fast access to the CAN controllers due to direct memory mapping
•
Support of the READY line (can be switched off via DIP switch)
•
Basic addresses beginning with C000H can be set in 4 k steps via DIP switch, occu-
pying 4 kbytes of address space
•
Bus interface according to ISO 11898-2 on-board, galvanically isolated as an option
•
Optional CAN protective circuit on-board
•
CAN connection via 9-pin Sub-D connector / Sub-D socket
•
Pin allocation according to CiA/DS-102
Copyright IXXAT Automation GmbH
PC-I 03 - Manual, Version 3.2
5
Содержание PC-I 03
Страница 4: ......
