IWILL P4DA, Руководство пользователя, Страница: 85 / 96

6: Using The Motherboard
○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○
User’s Manual 6•3
○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○
Indicator LEDs
The motherboard front panel features connector supports
three system status indicator LEDs:
• Power Status LED Indicator
Lights when the system is turned on.
• Hard Disk Drive Activity LED Indicator
Flashes during hard disk drive access.
• Power Conservation Mode LED Indicator
Lights to indicate the system is in a Suspend state
power conservation mode.
Most system housings will have all of these LEDs mounted
in the housing’s front panel.
System Wake Up Features
This motherboard supports two system “Wake Up” fea-
tures that allow the system to resume from a Suspend
state in response to a hardware event. These features,
Wake-on LAN and Wake-On-Ring require PCI interface
cards that support these features.
Wake-on LAN (WOL)
Function: The system wakes up in response to a signal
arriving over a LAN that it is connected to.
Use: The onboard WOL connector supports connection
to a PCI Network Interface Card. The WOL cable from
the card connects to the WOL connector on the board.
This feature is not enabled by default in the Power Man-
agement section of the CMOS Setup Utility. If you want
to use it, set the “Wake-Up by PCI card” item to Enabled.
Wake-On-Modem (WOM)
Function: The system wakes up in response to a ring
signal to an internal modem it is connected to.
Use: The onboard WOM connector supports a connec-
tion to an internal PCI card modem with the WOR fea-
ture. The WOR cable from the card connects to the WOR
connector on the board.
The feature is not enabled by default in the Power Man-
agement section of the CMOS Setup Utility. If you want
to use it, set the “Wake-Up by Ring” item to Enabled.